So I was in need of a remote starter switch on a recent project I worked on – a 67 Volkswagen. I didn’t want to go and buy one – not even sure I could have found one in this day and age but it would make figuring out the car’s problem a lot easier.

I rummaged around a bit and while what I came up with works, you don’t have to come up with the same items to get the same result. The following is my list of bits and pieces that I used to make my starter switch.

Old prescription bottle
Piece of leftover extension cord
Push button switch
2 Terminals
2 Electrical clamps

I drilled a hole in the bottom of the bottle that would fit the push button switch, then drilled another hole in the bottle cap to fit the extension cord. Next was attaching the wire to the switch. The extension cord piece I had was about 5 feet long, you can make it any length you want. The cord was a 3 conductor piece and I cut the covering back about 8-9 inches. Again you can make yours longer or shorter as needed. I also cut off the ground wire as it would not be needed. I crimped terminals on the remaining wires and attached them to the push button switch with the provided screws. You can also use a toggle switch if that is what you have available.

You then place the switch inside the bottle and fasten it in place, then put the cord (or wires) through the hole in the cap and attach the cap. The last thing to do is attach the electrical clamps. I had a few that had been cutoff of some other item in the past – I constantly do this before tossing things out as it might come in handy someday. I soldered my wires to the clamps but you can also just attach them with other methods. Some clamps have a way to crush the wire to them, others have a screw on them that hold the wire.

So, using the starter switch is pretty easy. One clip goes to your positive battery post and the other clip goes to the connector on your starter solenoid that would be the “S” terminal or Start terminal. With the switch connected you can now “bump” the engine with the starter to perform valve settings, or spin a new engine to bring up oil pressure before starting it or it can be used to help you perform a compression test. You can also use it to diagnose a starting condition and determine if the battery might be marginal. It has a lot of uses and not just for the starter either. Not sure if that switch for the wiper motor is faulty or not? Connect this switch between the battery and the 12v input terminal on the wiper motor. If the wiper motor operates, there’s a good chance the wiper switch is bad.

I hope you enjoy this little item and please share the article with your friends.